Thermaltake V-Tubler 4T/DIY LCS/OD:3/4inch ID:1/2inch Lenght 2m Transparent | CL-W019-OS00TR-A
Thermaltake Flexible Tubing V-Tubler 4T 1/2’’ (13 mm)
Thermaltake introduces the V-Tubler 4T water tubing for custom PC water cooling configurations. Manufactured from medical grade PVC material, the V-Tubler resists twisting and collapse allowing for tighter bends without the kinking that can cause cooling failures or a reduction in system performance. Designed for use with 1/2” barbs and compression fittings, give users better mounting, easier fitting, and ideal flow. Choose from: ID 1/2” or 3/8” to make your system a showcase for all to see with the Thermaltake V-Tubler water tubing.
Tt LCS Certified is a Thermaltake exclusive certification applied to only products that pass the design and hardcore enthusiasts standards that a true LCS chassis should be held to. The Tt LCS certification was created so that we at Thermaltake can designate to all power users which chassis have been tested to be best compatible with extreme liquid cooling configurations to ensure you get the best performance from the best features and fitment.
Medical Grade Construction
Made in Taiwan, the V-Tubler 4T is constructed from medical grade PVC which is reliable, non-toxic, and substance free. Smooth inner walls improve closed loop sanitation, reducing particular gathering/entrapment onto the tubing wall. Working temperature range from -4℉ (-20℃) to 140℉ (60℃).
– Inner diameter: 1/2” (13 mm)- Outer diameter: 3/4” (19 mm) Material of V-Tubler 4T as below:
Designed for use with 1/2” barbs and compression fittings, V-Tubler 4T is pre cut into retail coils of 200cm lengths, allowing enthusiasts to build up aesthetically-superior water cooling systems by allocating the radiators to each particular component and incorporating externally-modular upgrades for their chassis.
Thermaltake recommends the following steps to be taken after completing your water loop setup
It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
Fill the reservoir to the top as it will prevent air from going into the pump
If necessary tilt the system slightly from side to side to bleed the air out of the loop.
Place some paper towels under fittings and joining points to test for leaks.
Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop
10 in stock
|Dimensions||150 × 150 × 10 cm|
CL-W019-OS00TR-A / #13992
Only logged in customers who have purchased this product may leave a review.