Thermaltake V-Tubler PETG Tube 12mm OD, 10mm ID, 1000mm – 4 Pack | CL-W142-PL12TR-A
Thermaltake V-Tubler PETG Tube 12mm OD 10mm ID 1000mm 4 PackThermaltake introduces the V-Tubler PETG solid tubing for custom PC water cooling configurations. Manufactured from premium PETG, the V-Tubler rigid tubing allows users to route the tubes runs exactly to their heart’s content. Designed with 12mm OD PETG tube adapter fittings, it gives users better mounting, easier fitting, and ideal flow to make your system a showcase for all to see.Tt LCS CertifiedTt LCS Certified is a Thermaltake exclusive certification applied to only products that pass the design and hardcore enthusiasts standards that a true LCS chassis should be held to. The Tt LCS certification was created so that we at Thermaltake can designate to all power users which chassis have been tested to be best compatible with extreme liquid cooling configurations to ensure you get the best performance from the best features and fitment.100% PETG Material100% PETG Material Made in Taiwan, the V-Tubler PETG Tube is constructed from superior PETG material which is reliable, non-toxic, and substance free. Thicker walls ensure safe operation, enabling the users to make the straightest run as well as tightest bends without the need of excessive compression fittings and 90 degree angle rotaries. Working temperature ranges from -4℉ (-20℃) to 143.6℉ (62℃). – Outer Diameter: 12 mm – Inner Diameter: 10 mm – Length: 1000mm*4Remarkable ExpansionDesigned for use with 12mm OD PETG tube adapter fittings, V-Tubler PETG Tube is pre cut into retail coils of four 1000mm lengths, allowing enthusiasts to build up aesthetically-superior water cooling systems by allocating the radiators to each particular component and incorporating externally-modular upgrades for their chassis.*Coolant operating temperature exceeds 50℃/122°F may potentially affect the PETG tube.*Thermaltake V-Tubler PETG Tube Series is recommended for use with the Pacific Temperature Sensor.CautionThermaltake recommends the following steps to be taken after completing your water loop setupIt is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediatelyFill the reservoir to the top as it will prevent air from going into the pumpIf necessary tilt the system slightly from side to side to bleed the air out of the loop.Place some paper towels under fittings and joining points to test for leaks.Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loopBefore starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.Coolant might fade over time.
10 in stock
|Dimensions||150 × 150 × 10 cm|
CL-W142-PL12TR-A / #24291
Only logged in customers who have purchased this product may leave a review.